Semi-automatic coaxial wire strippers troubleshooting problems: head sometimes does not rotate Workaround: 1. DC brush type motor brush wear quality wire strippers Which is good, replace the carbon brush or the motor problem: the jaw, head and sometimes not action or movement in one direction only solution: 2. Check the sensor chip and the sensor if there is too much dust semi-automatic coaxial strippers, or the working environment humidity caused by water on the sensor, if so, clean up clean. 3. Check whether the sensor has been lit or not lit, if so, the sensor is damaged, replace the sensor, replace the good, the need to see whether the normal operation of each motor in manual state. Semi-automatic coaxial wire strippers and maintenance methods and how to change a blade installed for the blade 1 after reset into the manual mode, the manual forward / backward behind the set 1500-2000, point hand back, easy to operate so that the tip retreated position. 2, remove the head on both sides of shrapnel, and then remove the blade clamp mounted automatic coaxial wire strippers, remove the old blade blade will still look new blade mounted on coaxial strippers, blade mount fixtures To ensure a clean, smooth sliding. 3. When loading jig to note that mark jig and tool head (A to A, B to B), can not hold against, and then install the shrapnel into the manual mode can be reset. Stripping Machine Which is good _DAUMAK (certified) _ coaxial wire strippers provided by the Dongguan City Code ching Machinery Co. Zhen Machinery Co., Ltd., Dongguan City Code (www.daumak.com) is a leader in Dongguan, electronics, electrical products manufacturing equipment, over the years, the company implement the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs . In a typical frame machinery leadership with the staff warmly welcome all inquiries negotiations to create the typical mechanical frame a better future.